|Bed leveled with washers|
As Brook suggested, the bed needs to be leveled with washers on the four corners. After some time, I figured out that the best way to do this is to put the same size washer under each corner so you have the ability to move each corner up or down as needed. I used a pair of Digital Calipers to measure the thickness of the washers I had. The majority of them seemed to be 1.5mm so I used that as the base on each corner, but I also had washers with thicknesses of 1.3mm, 1.4mm, 1.6mm, 1.7mm, among others so I could swap the washers out to get small adjustments in the Z-direction in each corner. I once again checked the area of the Printrbed with a slice of paper in between the bed and the extruder tip, and although it was not perfect, the next object that I printed came out without a hitch. That object, by the way, was Pi Keychain / Backpack Charm by CodeCreations.
|Freshly printed keychain|
|Although I only printed it because it was simple,|
it should prevent me from losing this flash drive.